BIOCODE AUTO M10Automobile anticreeping system BIOCODE-AUTO M10 is intended for protection of the car against stealing and capture. By means of the special scanner the system defines the owner on its fingerprint that excludes any possibilities of interception of a signal and not authorised access to the protected car. Tiny capacitor the scanner differs simplicity of installation and is organically entered in a salon interior. Print comparison occurs on tens parametres and gives 100 % a guarantee in confident reading under various conditions. Thanks to application of intellectual digital relays remote blocking (RDU, RDUK or RDD), operated on regular electroconducting, at not authorised access the car engine will be reliably blocked.

In case of use of relay RDU or RDUK engine blocking occurs after ignition inclusion, and relays RDD with the movement gauge allow to support remote autostart and to make blocking of the engine with the beginning of movement of the car.

Digital relays of remote blocking in execution with normally closed contacts provide protection against search of the blocked chains of the car by means of the diagnostic equipment. For increase of reserve of installation of relay RDU, RDD are executed in the form of usual regular automobile relays. And relay RDUK design allows to carry out its installation by “plait” of regular electroconducting of the car. The quantity of relays established in the car is not limited.

Protection of doors, cowl, luggage carrier and ignition system

Blocking of the engine of the car

Additional blocking of the engine of the car

Built in immobiliser

Emergency statement of the auto alarm system on protection

Emergency removal of the auto alarm system from protection

Silent removal of the auto alarm system from protection

Automatic statement of the auto alarm system in a protection mode

Automatic restatement of the alarm system in a protection mode

Two-step-by-step switching-off of a mode of protection by the auto alarm system

The two-level gauge of blow of the auto alarm system

The central lock built in the alarm system

Programmed impulse of the central lock

Two-step-by-step opening of the central lock

Management of the central lock at the got engine of the car

The built in relay parking fires

Additional channels: 3 (1 prog.) (1 power)

The delay account interior illumination

Function of polite illumination

The temperature gauge
BIOCODE AUTO M10
To look the prices

System BIOCODE-AUTO M10 does not demand presence of the computer for programming, that considerably simplifies procedure of installation and the subsequent operation. In memory of system can be brought to 10 prints of fingers.

BIOCODE-AUTO M10 possesses a number of functions interfering power capture of the car. It is the control over opening of a door of the driver, and also a special mode “a disturbing finger” - when the owner, in case of constraint by its malefactors to get the engine, puts to the scanner a finger which status in a database of users is “disturbing”, and after 5 minutes there is an engine blocking.

The system can be established in any cars and does not break work of regular electronics. The newest technology of data transmission in which the original way of modulation is used, provides impossibility of interception of a signal of management a code-grabberami.

Technical characteristics Biocode Auto M10:

* maximum time of identification - no more than 2 seconds
* a maximum quantity guarding in memory of prints of fingers - 10 pieces
* the quantity of connected relays RDU, RDUK, RDD - is not limited
* the maximum switched current of the relay - 15 And
* power consumption of each relay - no more than 1 volt
* power consumption of the control block (without the relay) - no more than 3 volts
* working temperature - from-40S to +85С
* relative humidity of air at temperature +25С - 98 %
* a food - from a network of a direct current of the car pressure from 9В to 15В
* overall dimensions of the control block - 110х55х30 mm
* overall dimensions of the scanner of prints of fingers - 39×24x10 mm

Completeness of delivery Biocode Auto M10:

* the control block - 1 piece
* the scanner of prints of fingers with light-emitting diodes - 1 piece
* the relay of remote blocking - 1 piece
* a cable connecting - 1 piece
* button VALET with a cable - 1 piece
* the fixture complete set
* an envelope with a PIN-code
* the user’s guide
* the instruction on installation and programming